Wood Rack Profile/Layout

  • 30 Oct 2018 11:53 PM
    Message # 6881882

    Hi Rob

    You asked for suggestions so here are a couple.

    1: Instead of clamping the legs to the blocks screw a second block on the inside of each leg. This will hold the legs in place and allow a repeatable process.

    2: Use blocks at the end of each shelf/support to assist in placement of the support and avoid having to measure each one individually.

    Loved the PHP videos of the actual classes, great idea.

    Regards

    John

  • 30 Oct 2018 11:58 PM
    Reply # 6881900 on 6881882

    I forgot to explain in my first post re point 1: the inside blocks should be fixed with one screw in the center to act as a pivot point. Locate each about 1/4 inch away from the back of the leg and place the leg down then rotate the block to hold it in place. A sort of cam effect. This will allow for any variations in width of your lumber.

    Cheers

    John

E-Mail Support                                                                                                                                RobCosman.com

Rob Cosman's Signature Hand Tools




This site is maintained by AlphaOneStudios
Powered by Wild Apricot Membership Software