Miter Gauge Slop

  • 28 Jul 2017 10:43 AM
    Message # 4999819

    Rob,

    I have the same saw you do.  The ONLY complaint I've ever had with it was the miter gauge that came with the saw. I couldn't get it to hold the settings.  My solution was to replace it with an after market gauge from Incra.  That solved the issue.  I spent a lot of time chasing small errors when I realized the problem was that the gauge kept slipping very slightly at random times, no matter how tight it was screwed down.  After the replacement, no more problems.  I relegated the original gauge to my router table.  Other than the gauge, the Sawstop ICS is a most fantastic cabinet saw.  

    Regards,

    Tom

  • 28 Jul 2017 8:01 PM
    Reply # 5000734 on 4999819
    ROB COSMAN (Administrator)

    Hi Tom, funny to have gone this long without noticing that but i dont use a miter gauge that often.  I hope this has been brought to their attention already.  cheers

    Rob

E-Mail Support                                                                                                                                RobCosman.com

Rob Cosman's Signature Hand Tools




This site is maintained by AlphaOneStudios
Powered by Wild Apricot Membership Software