Better way?

  • 13 Oct 2017 1:23 AM
    Message # 5311831

    What if you took a board and put it across all the spindles and taped every spindle to it, then pounded it in? Have you tried this? Downside?

  • 17 Oct 2017 1:53 PM
    Reply # 5318570 on 5311831
    Anonymous

    I wondered about the same thing.  Another thought would be to purposely make the spindles in slightly different lengths and perhaps put the longer ones in on either end and work toward the middle (or maybe center out)?  At the end of the video Rob opined that he put the top rail on last on the other two builds.  Was it any easier or did it camouflage any damage done because the damage would have been on the bottom of the rail?

E-Mail Support                                                                                                                                RobCosman.com

Rob Cosman's Signature Hand Tools




This site is maintained by AlphaOneStudios
Powered by Wild Apricot Membership Software