Shaker Bench dowel jig

  • 20 Jul 2017 10:33 AM
    Message # 4986214

    Question, Would it have been easier and more accurate to drill the hole perpendicular and plane the bottom of the jig to sit at 10 degrees? Or would that have caused a clamping issue?  

  • 26 Jul 2017 6:47 AM
    Reply # 4995494 on 4986214

    In my opinion. I would do it the same way, then I could fine tune just like was done here. But I guess you're idea would work as well. Also, it depends on how much material you actually want to remove. And I think it would be harder if you are a little off in both directions. 

E-Mail Support                                                                                                                                RobCosman.com

Rob Cosman's Signature Hand Tools




This site is maintained by AlphaOneStudios
Powered by Wild Apricot Membership Software